700km relocation De Vere 507

I’ve been on a road trip to pick up a De Vere 507 medium format enlarger from same guy I bought a Linhof Technorama 617 from. I’d done lots of research and was ‘confident’ it would fit in my little 4WD, but yesterday was ‘find out’ day…

Lengthwise it was ok but the base legs were too long to fit in vertical, so we had to rotate it… At one point we had it in, but I couldn’t change gears as it was blocking the Suzukis gear lever… But we eventually fitted it in, with inches to spare! The rear door would close, so I then repacked all my camping gear in around it. The car was so full!!

Phew!!! There were only a couple of backup options: gaffer tape the Suzukis rear door partially open? Remove the legs/feet from the 507, which I think is possible but I wasn’t sure I had the tools for…

This is it assembled – we took the head off & carefully packed it… And the big base board went on my roof rack… Next mission is to DIY an LED head for it

Over a couple of days I drove from Palmerston (near Dunedin) to Ashburton, then on to Blenheim, then on to ferry & home.

The night I got home, I unloaded everything else but left the De Vere in my car as I needed to strategise how to get it into my house…

The next morning I had a plan.
First I’d get it out of the car, by sliding it on some soft objects like my tent & sleeping bag.

This worked well, and once it was hanging out the back of my 4WD, I slowly lowered the base and then stood it up – revealing how tall it is: 2,200mm = 7 feet 2.5 inches!

This was the path I now needed to move it up:

A to B is flat-ish
B to C is gentle incline
C to D is gentle incline
E = sunroom
F = hall between dark room & foley room
G = dark room

I figured getting it to the sunroom was critical, as it was then safe from weather etc..
Having moved an upright piano by myself, as explained in this post I figured I’d used the same strategy ie move it a foot, rest. Move it a foot, rest.

I’d guess it only took me half an hour to get it to the sunroom…
where the ceiling is too low to stand it upright, so I left it leaning against a wall.

Then, after a rest, through into the hall:

The next moves really took some effort, both thinking about how to manipulate it in 3 dimensional space and how to manage its weight, so it didn’t crush me… all while coping with height and width restrictions of each door & ceiling!

The width of the baseboard-support restricted sideways movement, and after much wrangling I decided I would have to lie it down to get it into my dark room, due to the angle between the two doors…

Bingo, I had it into the small room I use as a dark room….

But having come all this way, I now had to face the final issue:

Hmmmmmm…. Even with the carpet & underlay removed the ceiling was too low to stand the 507 upright. I left it in this position overnight, as I pondered the best solution.

By the next morning I had an idea. I suspected the ceiling in that room was a false ceiling – it sounded hollow when I thumped it – was it suspended plasterboard? I got a battery drill and drilled a hole in it & then pushed a drum stick through the hole. AHAR!!! There was a 3 inch gap before the actual ceiling! I had my solution – remove the plasterboard ceiling!

Half an hours work the next morning and it was done!

Next:
– align and level all elements as per this youtube video
– install the Dichroic Head
– connect the controller & power supply

Then I can mount a lens, load a negative and see it in action!!

 

Welcome to your new home, De Vere 507!

Your forever home…

 

 

Leave a Reply

Your email address will not be published. Required fields are marked *